The RPi Zero has the same pinout as the RPi1 Model A+, B+, and 2B

rpi_zero_io_pinouts

 

 

USEFUL?
We benefit hugely from resources on the web so we decided we should try and give back some of our knowledge and resources to the community by opening up many of our company’s internal notes and libraries through mini sites like this. We hope you find the site helpful.
Please feel free to comment if you can add help to this page or point out issues and solutions you have found, but please note that we do not provide support on this site. If you need help with a problem please use one of the many online forums.

Comments

  1. albertmelissen

    7 years ago

    Is there any way to add extra USB ports on the Pi Zero? I know that the processor supports more than the single USB port but can any more be added, perhaps by soldering wires directly to pads/test points on the underside of the board?
    Thanks.

    1. Adam

      7 years ago

      Just use a USB hub, the standard RPi simply has a USB hub IC built in

    2. albertmelissen

      7 years ago

      Thanks, that is plan B. I’m prototyping an embedded system that connects to an arduino I/O processor via the USB.
      The final design will use the SPI interface. I was hoping to be able to build it all into a small case without tying up the existing USB port.

Leave a Reply to albertmelissen Cancel reply

Your email address will not be published. Required fields are marked *